index
VETERAN OWNED MADE IN THE U.S CUSTOM ORDERS SHIP WITHIN 1–8 BUSINESS DAYS BECOME AN AFFILAITE VETERAN OWNED MADE IN THE U.S CUSTOM ORDERS SHIP WITHIN 1–8 BUSINESS DAYS BECOME AN AFFILAITE VETERAN OWNED MADE IN THE U.S CUSTOM ORDERS SHIP WITHIN 1–8 BUSINESS DAYS BECOME AN AFFILAITE VETERAN OWNED MADE IN THE U.S CUSTOM ORDERS SHIP WITHIN 1–8 BUSINESS DAYS BECOME AN AFFILAITE VETERAN OWNED MADE IN THE U.S CUSTOM ORDERS SHIP WITHIN 1–8 BUSINESS DAYS BECOME AN AFFILAITE VETERAN OWNED MADE IN THE U.S CUSTOM ORDERS SHIP WITHIN 1–8 BUSINESS DAYS BECOME AN AFFILAITE VETERAN OWNED MADE IN THE U.S CUSTOM ORDERS SHIP WITHIN 1–8 BUSINESS DAYS BECOME AN AFFILAITE VETERAN OWNED MADE IN THE U.S CUSTOM ORDERS SHIP WITHIN 1–8 BUSINESS DAYS BECOME AN AFFILAITE VETERAN OWNED MADE IN THE U.S CUSTOM ORDERS SHIP WITHIN 1–8 BUSINESS DAYS BECOME AN AFFILAITE VETERAN OWNED MADE IN THE U.S CUSTOM ORDERS SHIP WITHIN 1–8 BUSINESS DAYS BECOME AN AFFILAITE

PREPARING YOUR PROP FOR INSTALLATION

IT USUALLY WORKS BEST TO INSTALL THE BOLT FROM THE FRONT (SMOOTH SIDE) OF THE PROP. DEPENDING ON THE CAR, SOME USERS MAY PREFER TO HAVE THE BOLT FACING FORWARD INSTEAD.
ONCE THE BOLT IS FULLY INSERTED, THREAD ONE NUT ALL THE WAY TO THE ACRYLIC, DO NOT OVERTIGHTEN. THEN INSTALL THE SECONDARY NUT APPROXIMATELY 1/2" ONTO THE BOLT. PICTURE IS FOR REFERENCE , ADJUST AS NEEDED.

ADDING YOUR LIGHTS

TO INSTALL THE LIGHT UNIT, IT IS RECOMMENDED TO INSERT THEM FROM THE BACK SIDE OF THE PROP (THE ENGRAVED / TEXTURED SIDE) WITH THE ROUND BUTTON FACING THE FRONT. START BY POSITIONING THE LIGHT AT A SLIGHT ANGLE, BEGINNING WITH THE OPEN/EXPOSED SIDE AS SHOWN.
GENTLY SQUEEZE THE TOP AND BOTTOM OF THE LIGHT UNTIL IT SITS FLUSH WITHIN THE SQUARE HOLE ON YOUR PROP, LIKE SHOWN IN PICTURE.
REPEAT FOR ADDITIONAL LIGHTS IF NECESSARY, MAKING SURE THE LED IS FACING THE GRAPHIC DESIGN. THE LIGHT SHOULD LOOK LIKE THIS ONCE FULLY INSTALLED.

Installing your prop

HOOK THE UPPER LOOP OF THE PROP TO THE HOOD STRIKER LATCH.
IMPORTANT NOTE*
MANUALLY MOVE THE HOOD SAFETY LATCH LEVER AND REST THE BOLT INSIDE THE EXPOSED MECHANISM, THEN RELEASE THE LATCH. NEVER APPLY PRESSURE TO THE BOLT WHILE IT IS INSTALLED IN THE PROP, AS THE LEVERAGE AND FORCE COULD BREAK THE BOTTOM OF YOUR PROP.
THE BOLT SHOULD LOOK SIMILAR TO THIS ONCE FULLY LOCKED INTO PLACE. THE SECOND NUT HELPS PREVENT THE BOLT FROM UNINTENTIONALLY SLIPPING OUT OF THE LATCH MECHANISM AND MAY NOT BE USEFUL IN EVERY SITUATION.